Tangential Lathe Tool Holder Plans. The phase ii qctp comes with several toolholders but more would be better, allowing more bits and the clamp knurler to be instantly available. They are reported to be simple to use, cut aggressively and leave good surface finish.
Tangential toolholders evovling in my shop: The turnado freehand metal turning system. Included are all models and drawings for rh and lh toolholders, grinding jig for 1/4 square tool steel bits, assembly details for.
I decide to try it out but first of. It will be cut 2 threads proud of flush with the nut. The tool fits in a milled slot that is slightly less than 1/8 deep and it is clamped in place by an m4 screw.
Tangential toolholders evovling in my shop: Hey these are already made for sale by a nice man in australia. The only problem is the price of the axa holders, typically upwards of $15 on ebay, more from a regular supplier.
Tool holder size will depend on a combination of size of your lathe and type of tool post fitted. They are reported to be simple to use, cut aggressively and leave good surface finish. Check tool height and size of tool slot in tool post before purchasing.
This should work ok for me because i'm using a norman patent style of qctp and can split the angles between the main block (that mounts on the post) and a second piece that will bolt onto a sloped face of the block. Mount the tongue of the outer frame (approximately 3/8 square) in your lathe's tool post. Model number indicates distance in millimeters from bottom of tool post tool slot to lathe centerline.
It was once measured by a boing 737 (old model) captain that i could decide to stop,remove toolholder ,regrind.put back on lathe and start cutting again in less than two minutes. As soon as i heard about this type of toolholder from mike's workshop, i was intrigued.there seem to be many different designs around and they all need a milling machine! This is an excerpt from a longer shop tour video with.
Comments
Post a Comment